![]() All other combo models: Use Composite Video or RF. To view DVD and VHS output on the same connection: DVD-VR325, Use HDMI, Composite Video, or RF. Use the remote control that came with the TV set ( notthe Blue Ridge remote), or channel +/- buttons on the TV set itself to make sure the TV set is on either channel 3 or 4. To view broadcast or VHS playback, switch the televisions signal source to either Cable (if using the RF connection) or Line In (if using composite video) to view broadcast and VHS playback. This could be as simple as oxide shed and head clog, or it could be a failure of the electronics themselves. I would therefore suggest that the issue lies with the VCR and that it cannot output a stable video signal due to a fault. However, the TV will need to be set to either channel 3 or 4 to get a signal. If you are seeing the JVC logo, the connection is fine. If you have a DTA Mini Box or a Cisco or Scientific Atlanta digital box connected by a coaxial cable that screws into a cable jack on the back of your TV, you may need to select this input. Snow or static on the TV screen indicates your TV is on the basic cable, analog, or antenna input. You may need to refer to the documentation that came with your TV set for further information. If you do not have the remote that came with the TV, walk up to the TV set and look for an Input or Source button on the set itself. Try each one until you have picture and sound. Pressing the button may change the input, or bring up a menu from which you will need to select the correct input. Other remotes may simply have an image of a plug, or a picture of an arrow entering a square. If you are using an audio receiver or other device (VCR/DVD/etc.) connected between the TV and DISH receiver, power it on as well. Depending on the TV, you may need to press this button multiple times to either cycle through inputs, or select an option in the corresponding menu.Īs another option, on the remote that came with your TV set ( not the Blue Ridge remote), look for a button labeled Input, Source, or TV/VCR. If you’ve programmed your Blue Ridge remote to the TV, you may be able to change the input on your TV by pressing the or button. Look for status lights that indicate it’s online. Please note that your TV may differ in terms of onscreen messages, remote buttons, or terminology related to its various inputs.įirst, make sure the cable box is powered on. For example, if your cable box is plugged into the HDMI 1 port on the back of your TV, then the TV must be set to the corresponding HDMI 1 input to get a picture.Īn accidental button-press or a brief power outage may cause the TV to switch to an incorrect input. Many modern TVs have multiple ports or ways to connect devices such as cable boxes, DVD Players, or gaming consoles, and your TV must be told which input to view in order to receive a signal. A No Signal message, or a blank screen with no audio, may indicate that your TV is on the wrong input to receive a signal from your cable box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |